60A MPPT Solar Panel Regulator Charge Controller Auto 12/24/36/48V Dual

Description: 60A MPPT Solar Panel Regulator Charge Controller Auto 12/24/36/48V Dual PowMr Solar Charger Controller MPPT 60A 12V 24V 36V 48V Blacklight LCD Regulator Max PV Input 150VDC Support Lithium batteries Advantages: 【60A MPPT CHARGING CONTROLLER】 4-stage battery charging algorithm for a rapid, efficient, safe charging(Bulk Charge, Boost Charge, Float Charge, and Equalization), 60amp Rate Charging current. 【Controller WIDE RANGE SOLAR VOLTAGE/POWER SUPPORT】Controller supports High PV Input Power/voltage. The controller can accept Solar voltage up to 190V. When battery is 12V system: Suggest Solar power 720W, suggest range:DC20V~DC80V；1440W 105V when 24V; 2100W 150 when 36V; 2800W 150v when 48V. 【12V/24V/36V/48V BATTERY SUPPORT】Negative grounding design controller safer, controller Compatible with a variety of batteries(lead-acid and lithium, User customize); Sealed, Gel, Flooded and LI (LFP) battery charging parameter pre-set, other battery can be customize charging parameter according to your need. 【0 layer MPPT charge controller】Easy to know the Charging process in one glance. 【FULL CHARGING PROTECTIONS】Short Circuit/Overcurrent/Reverse Polarity, etc. protections; a Very detailed LCD screen and 4 buttons make this solar controller very simple to use. And detailed troubleshooting list, Fast service support, and Simple and detailed wiring instruction are available. Feature:This controller features a smart tracking algorithm that maximizes the energy from the solar PV module(s) and charges the battery. At the same time, the low voltage disconnect function (LVD) will prevent the battery from over-discharging.The 0 layer's charging process has been optimized for long battery life and improved system performance.Electronic protection: Overcharging, over-discharging, overload, and short circuitReverse protection: Any combination of solar module and battery, without causing damage to any componentController charging happens when solar panels' voltage is higher than batteries.Lithium Battery Activation: this has a reactivation feature to awaken a sleeping lithium battery. The 0 layers will apply a small charge current to activate the protection circuit and if a correct cell voltage can be reached, it starts a normal charge. Specification:Technical Specification for Selection GuideModelsPOW-M60-PROCharging modeMPPT Maximum power point tracking automaticallyCharging3-stage:constant current(MPPT), constant voltage(Absorption Voltage), floating chargeSystem typeDC12V/24V/36V/48V Recognition automaticallySystem voltage automatic recognition1 2V system (DC9V-DC15V)24V system (DC18V-DC29V)36V system (DC30V-DC39V)48V system (DC40VDC60V)Soft start time<1SDynamic response and recovery time>98.1 % (Voc is 1.5 or 2 times than battery, then it's the best efficiency)PV utilization>99%Input specificationVOC from PV( Make sure the Voc of PV meets the requirement right. Voc is 1.5 or 2 times than battery, then it's the best efficiency.)12V system (DC20VDC80V)24V system (DC37V-DC105V)36V system (DC50VDC160V)48V system (DC72VDC160V)The maximum PV input voltage (Voc)DC190V(The controller can't work at this voltage of a long duration that will break the controller. Please refer to the Input voltage from PV.)The maximum PV input power (The total power rated of PV can't be over this watt that will break the controller.)12V system (720W)24V system (1440W)36V system (2100W)48V system (2800W)Output specificationSelectable battery type(default is Sealed)Vented/ Sealed / Gel / NiCd / Lithium battery(defined voltage for other battery by user)Absorption Charging VoltageRefer to Batteries charging referenceFloating Charging VoltageRefer to Batteries charging referenceOvercharging protection voltage12V system (15V)24V system (30V)36V system (45V)48V system (60V)Rated output current60ATemperature Coefficient±0.02%/ °CAutomatic temperature compensation14.2V-(Max temperature-25 °C)*0.3Output voltage ripple-peak100mvOutput voltage accuracy<±1%Input Anti-intrusion protectionyesTemperature Protection75°CTemperature increased protectionOutput power will reduce when it's more than 70 °COutput power will be normal when it's less than 55 °CFan-on temperature>40 °CFan-off temperature<35 °CAcoustic noise<40dBCooling wayForced air coolingComponentsImported materials, Accord to EU standards, Industrial grade range.Environmental requirementsMeet 2002/95/EC; No cadmium, hydrides, and fluoridesSecurity LevelAccord to CE, PSE, FCC, EMC, EN60950Electromagnetic CompatibilityAccord to EN6W00, EN55022, EN55024EnclosureIP21Net weight(Kg)1.3Gross weight(Kg)1.5 60A Controller Charging parameterSystem voltage: 12V / 24V / 36V / 48V DC AutoRated charge current: 60ASuggestion wiring:when battery 12V, suggest input solar voltage range DC20V~DC80V; Solar power 720W;when battery 24V, suggest input solar voltage range DC37V~DC105; Solar power 1440W;when battery 36V, suggest input solar voltage range DC50V~DC160V; Solar power 2100W;when battery 48V, suggest input solar voltage range DC72V~DC160V;Solar power 2800W; Battery support:12V 24V 36V 48V Deep cycle Sealed, Gel, Flooded, and Lithium, User battery. (Support Customizable charging voltages)Battery System Voltage read: DC9V~DC15V (the controller will read as 12V system) / DC18V~DC30V (24V) / DC32V~DC40V (36 V) / DC42V~DC60V (48V) (First connection please make sure your battery has enough voltage) After controller read your battery, please select correct battery type.Package Includes1 x 60A MPPT Solar Charge Controller1 x English User Manual Mounting informationThe battery must be connected first. NEVER connect the solar panel array to the controller without a battery.Ensure input voltage does not exceed 190 VDC to prevent permanent damage.Do NOT let the positive (+) and negative (-) terminals of the battery touch each other.Do NOT connect any inverters or battery chargers to the load terminal of the charge controller.Place the controller on a vertical surface protected from direct sunlight, high temperatures, and water. Make sure there is good ventilation.Please check for Clearance, and verify that there is sufficient room to run wires and clearance above and below the controller for ventilation. The clearance should be at least 3 inches (75mm).About USDelivery DetailsTerms of salesContact usDelivery WorldwideAbout US PowMr is a global solar energy innovation application company. In the past ten years, we have provided related products and services to more than 150 countries worldwide. We are committed to promoting solar energy products to more application fields and scenarios. We advocate new energy life, improve new energy ecological technology, protect the natural environment, and realize the common progress of man and nature. Why PowMr? - Fast Delivery - Free Shipping - 24 months warranty 一Avg. response time 1 Hrs(WorkingDay) - PowMr Everywhere 1. “Highly Quality first, customer orientation”is our purpose. 2. PowMr will be committed to provide the best service to you! Delivery Details Our warehouses are located in California, we will ship goods out for you within 24 hours. We offers a variety of shipping methods such as USPS, UPS, FEDEX. 1. Shipment Time: Your order will be sent out WITHIN THE HANDLING TIME.HANDLING TIME are based on 1 business days (Monday to Friday) excluding Holidays and weekends. After sending out the item, we will send you a notification letter, with the shipment information of the tracking number. 2. Shipment Type: The order of multi items may be sent via MULTI PACKAGES.If your order is including MULTI ITEMS, we may send the item to you via MULTI PACKAGES. If something is missing in the first package you received, please don't open a case or return, please ask us first, we will check if your order is sent via multi packages. 3. Delivery Time: DIFFERENT LOCATION, DIFFERENT SHIPPING TIME.In normal condition, the shipping time is about 2-5 working days. Some of that may be 5-10 working days.If you want to check the delivery time of your order, please kindly ask us first. Last but not Least, PLEASE DON'T OPEN THE CASE AND RETURN REQUEST/LEAVE NEGATIVE FEEDBACK FOR US BEFORE Before sending us a letter!!!Any issues, please kindly contact the customer service of our store FIRST.Terms of sales 1. We provide 30 days money back on non-defective, undamaged, unused and resalable products. Product is not eligible for refund after the 30-day refund period has expired. 2. Our warranty does not extended to any products that are physically damaged or that are not under normal operating conditions as a result of misuse or improper installation on the buyer/user's part. 3. For all returned products, Please contact us for the returning address and Pls do not open return case. 4. In all cases, buyers pay shipping fees at their own cost to return products for exchange or refund. In return, we will be responsible for the postage of replacements. Refund will be made upon receipt of the returned item.Contact us1. Please contact us via eBay massage if you have any questions. We will reply you within 24 hours. 2. Feedback is important to us, we will leave positive to our customers. 3. We understand the concerns and frustrations you might have, and will do our endeavor to resolve the issues. Please give us the opportunity to resolve any problem. 4. Please email us before leaving any 1 or 2 ratings, negative feedback or open any dispute. Delivery Worldwide

Price: 88.99 USD

Location: Walnut, California

End Time: 2024-11-18T10:05:48.000Z

Shipping Cost: 0 USD